Network Component Box
Starting up a new project to combine all my network into one box.
No Rack at the house so this is just an experiment to see if it will work and get the equipment off the floor under the desk… Still in progress and plenty left to do!
3-28-2021: So today I figured out how to get the grommets to work but this box was found next to the dumpster and is actually just a drawer from a piece of furniture. I am almost thinking to start over because they used pressboard with plastic veneer – it’s just cheap drawer stock. I have this as a mock up I suppose and can make it work but now that I am into this build I have found a few issues that I am working through – All good I suppose. More to follow…So after attempting a few ideas on wire management I drilled this cheap paper pressboard veneer.
4-2-2021: Ok – so Amazon delivered and it was a help – Still plenty more to do and I even had a helper today….
4-8-2021: I found a new RF controller – it’s too funny and I couldn’t resist….
UPDATE – Finally got this done – New Video Below… Thank you…
Comments are Closed